How to Install a Timed Washing Machine Valve

Last updated September 7, 2023

A timed washing machine valve has an automatic timer that shuts off the water flow to your washing machine hoses. It prevents flooding as it lessens the pressure put on the hoses. This guide explains how to install a timed washing machine valve in your home.

Difficulty:

Intermediate

Duration:

Under 2 hours

Project Guide

Home Improvement Ideas

Appliance Guides

Video

Laundry Appliances

Interior Maintenance

winter

Fall

Summer

Spring

Laundry Room

Disconnect the Supply Lines
Solder the Pipe and Fittings
Fasten the Pipes

Disconnect the Supply Lines

Close the hot- and cold-water shutoff valves leading to the washing machine.
Disconnect the hoses from the back of the machine and slide the machine out of the way.
Tighten two brass 90-degree elbows onto the rear of the timed washing-machine valve.
Use the close-quartertubing cutter to cut into the existing hot- and cold-water supply pipes.

Solder the Pipe and Fittings

Clean the new copper pipe and fittings with the cleaning brush.
Use the acid brush to apply flux to the pipe ends and fittings.
Solder the new copper pipe and fittings onto the existing copper water-supply pipes.
Tighten the compression fittings on the brass elbows to secure the timed washing-machine valve to the copper water-supply pipes.

Fasten the Pipes

Fasten the copper pipes to the wall with ¾-inch screws and copper pipe clips.
Slide the washing machine back into position and connect its hot- and cold-water hoses to the valve.
Plug in washing machine's power cord, then open the hot- and cold-water shut-off valves.
Snap the plastic cover onto valve and open the valve by sliding its lever to the left.

Now that you know how to install a timed washing machine valve, you can prevent flooding in your home. With some basic plumbing skills and a little patience, you'll have it done in no time. Use the Home Depot Mobile App to locate products and check inventory. We’ll take you to the exact aisle and bay.