Bird Proof Gel is a safe bird repellent for ledges, window sills, gutters and beams to keep birds from roosting or landing. Discreet and low-profile, this non-toxic formula makes a surface sticky and uncomfortable to birds. Easy to apply with a standard caulking gun. Can be used in any weather, indoors or outdoors. Three cartridges treats 35 lin. ft. Product remains tacky and effective for up to 6 months. Use for pigeons, starlings or sparrows.
Dimensions: H 12.0 in, W 2.0 in, D 2.0 in
Product Depth (in.) | 2.0 in | Product Height (in.) | 12.0 in |
---|---|---|---|
Product Width (in.) | 2.0 in |
Concentrated or Ready to Use | Ready to use | Features | Sticky |
---|---|---|---|
Garden Pest Location | Not for Garden Use | Indoor/Outdoor | Outdoor |
Location | Interior Home | Organic | Non-Organic |
Pack Size | 3 | Pest Common Name | Bird |
Pest Control Type | Lawn Insect Control | Primary Active Ingredient | Polybutylene |
Product Form | Gel | Product Weight (lb.) | 3 lb |
Returnable | 90-Day | Safe For | Safe For Kids, Safe For Pets |
Safe for Edibles | No | Safe for Pets | Yes |
Spray Application Type | Gel |
No, not for woodpeckers.
Yes, you can apply but do to it being porous it will absorb some of the gel. Apply cautiously, do not make thick lines and should be applied in zig zag.
Depending on surface, you can use mineral spirits, or you can soak it with Dawn and warm Luke water and leave for 20 minutes and start removing the Gel. All depends on the surface.
No this will not work for Egyptian Geese. You need the Goose Buster unit.
Gel is not recommended for this problem. If the Mailman is placing magazines there then he will get the gel on hm and the magazines.
Not recommended as it will drip, and you do not want people touching the gel as it is very sticky.
No , you should not apply this on carpet. Apply as follows: Surfaces less than 4" wide, apply a ½"- in diameter bead approximately 1" in from the outside edge Surfaces greater than 4" but less than 8" wide, apply two beads about 2" apart, beginning approximately 1" in from the outside edge; wider surfaces, apply three beads, with the third bead located about 2" in from the second (5" in from the outside). GUTTERS, GUTTER BOXES DOWNSPOUTS: When birds nest in these areas, they clog the natural flow of water which can result in expensive roof and interior water damage. Treat the outermost tip of gutters, laying a continuous ½" bead the full length of the gutter. There should be breaks in the bead to allow water to flow into the gutters. Downspout curves under roof overhangs are occasionally the sites of nests and concentrated droppings. In order to treat the area properly, remove all nests and clean the surface before application. Apply two beads, beginning 1" in from each outside edge. PITCHED ROOF RIDGES, EAVES, DORMERS: Treat the entire length of the roof ridges (including eaves and dormers) with at least one continuous bead of gel. Don't forget to treat the flashing where eaves and dormers join the roof. Lay a series of broken beads 2" to 3" apart. Protrusions under the eaves of a dormer require treatment because birds build nests in these sheltered areas. CHIMNEYS: Apply gel along the outside edge of the chimney cap and along the flashing where the chimney joins the roof, a place where birds nest and seek warmth and shade. On the chimney cap, apply a single bead 1" in from the outside edge.BALCONIES. Where the tops of railings require bird-proofing, first protect the railing by covering with cloth tape; then apply gel over the tape. Also treat floors of balconies beneath railings 1" in from the outside edge. Be sure to caution residents to stay clear of treated areas. Remove the tape from the railing after the birds no longer return to the area. MONUMENTS, CURVED SURFACES: Apply where birds have been roosting or are likely to roost. COLUMN CAPS: Apply gel in ½" beads approximately 1" in from the outside edge of the cap and all areas adjacent to it, wherever evidence of birds is found. Remember, that besides being functional, columns and caps are designed to be attractive; therefore, neatness and attention to detail are important! SIGNS, MARQUEES, SUBSTRUCTURES & LETTERS: Turn off all electrical current before applying gel to lighted signs. Tar flashing, as well as the rest of the deck, may have to be cleaned thoroughly prior to application (this should be considered a bailable expense). Apply gel to all supporting beams and braces above and below the sign or marquee; the number of beads (strips) will depend on both the severity of the bird problem and the width of the surfaces. It may be helpful to have representatives from the sign service company present during applications to ensure that gel is not applied where personnel will be walking. To calculate the amount of gel required to treat a sign, measure the lineal footage from one end of the sign to the other, and multiply by three for estimating purposes. Don't forget to add rods, pins or structural steel frameworks that support the letters. LETTERING: Birds are likely to roost and build nests in these areas on the fronts and sides of buildings where letters have been mounted to spell out the company's name. Droppings make these areas unsightly. ORNAMENTAL TRIM (i.e. "gingerbread"): Be sure to clean all droppings from the ornamental trim before applying gel to all landing and nesting areas. Remember also that in order to retain the beauty of ornamental trim, it is imperative to be as neat as possible. Since ornamental trim is usually narrow, simply apply one ½" bead of gel to surfaces where birds land. ROSE WINDOWS, PORTHOLES: Since birds do not roost on vertical surfaces, it is only necessary to treat the horizontal roosting areas of rose windows or portholes with gel. Generally, one ½" bead along the edges is enough. Wider ledges may require two or more beads. Treat any cornice wide enough to serve as a landing site for birds. HINT: Pay extra careful attention to church rose windows when applying gel. These windows are extremely expensive to replace and are considered works of art. BELL TOWERS & STEEPLES: Although they vary in shape and size, these areas are treated like any other pitched areas. Hire steeplejacks on an hourly basis to work on ridges and other normally inaccessible areas where rigging and ladders cannot be used. If gutters surround the tower, remove nests and debris and treat the gutters and tops of downspouts. Screening in front of bell tower openings may be required after gel application (birds will not alight on treated areas, but instead may seek shelter inside the tower itself.) PARAPETS OR FIREWALLS - Usually capped with stone, tile asphalt, shingles, wood, tar, metal, etc., a parapet is the extension of a wall above the roofline of a structure. SPECIAL INDOOR APPLICATIONS - Follow suggestions above to apply on natural roosting areas such as interior beams, conduits, light fixtures, joists, pipes, etc., wherever birds are roosting. BEAMS, BRACES & STEEL STRUCTURES - Structural steel appears at many outdoor and indoor locations including aircraft hangars, loading docks, amusement park or race track decks, plant interiors, etc. Birds frequently roost in these areas. Applicators may be able to apply by walking along beams and braces with the caulking gun in hand and laying as many beads as necessary. Movable cranes and lift hoists are helpful where available. In other situations, ladders and additional equipment will facilitate application. When treating l-beams, apply to all four lips in areas of high bird concentration. The actual number of beads required will be determined by the severity of the bird problem. Apply a single continuous bead along each inside lip go structural steel or l-beam where nuisance bird problems are not intense; otherwise, lay additional beads.
This is not an item they eat. This is something that prevents them from landing.
Viewing 1-8 of 66
4.1 out of 5